We Have the Original Engineering Drawings for Your Press.
Wolverine has built presses for over 80 years. The original factory specs for your machine — every bolt, every tolerance, every component — are right here. Tell us what you need and we will send them to you.
- No hunting through supplier catalogs.
- No reverse-engineered guesswork.
- The actual drawings, from the company that built your press.
Every Third-Party Supplier Is Guessing. We're Not.
Every Wolverine press was manufactured to a specific set of engineering drawings. We still have them — every one, for every press we have ever built.
When you order parts from a third-party supplier, they are working from measurements taken off a machine, not the original design. Tolerances drift. Fit is close but not exact. Over time that shows up in how your press runs.
When you order from Wolverine, we source to the spec the press was built to. Same tolerances as the first day it started running.
Getting Your Drawing Takes About 60 Seconds.
STEP 01
Tell Us What You Need
Select your machine type and the drawing you need. Not sure what you have? Tell us that too.
STEP 02
We Send the Drawing
Our team pulls the original factory drawing for your machine and sends it to your email within one business day.
STEP 03
We Follow Up
A Wolverine team member will reach out to make sure you have what you need and answer questions about parts, service, or your press.
Request Your Assembly Drawing
Tell us your machine type and what drawing you need. We will send it to your email within one business day. Not sure what you’re looking for? Select “I’m not sure” and our team will call you.
Need Parts?
We source replacement parts to original engineering tolerances. No third-party guesswork.
Press Running Rough?
Wolverine still does factory-level service on every press we have ever built.
